B&R X67AM1323 X67 System I/O Module

I/O module:
- 2 analog inputs, 2 analog outputs, each 0 to 20 mA

General:
- B&R ID code: 0x1466
- Status indicators: I/O function per channel, supply voltage, bus function
- Diagnostics: inputs and I/O supply with status LED and SW status
- Connection technology:
- X2X link: M12 B-coded
- Inputs/outputs: 4x M12 A-coded
- I/O supply: M8 4-pin
- Power consumption:
- I/O internal: 3 W
- X2X link supply: 0.75 W
- Approvals:
- CE, UKCA, ATEX, IP67, TÜV, UL, HazLoc, EAC, KC

I/O supply:
- Rated voltage: 24 VDC
- Voltage range: 18 to 30 VDC
- Integrated protection function: reverse polarity protection
- Power consumption sensor/actuator supply: max. 12 W

Sensor/actuator supply:
- Voltage: I/O supply minus voltage drop across short-circuit protection
- Voltage drop across short-circuit protection at 0.5 A: max. 2 VDC
- Total current: max. 0.5 A
- Short-circuit proof: Yes

Analog inputs:
- Input: 0 to 20 mA
- Input type: differential input
- Digital converter resolution: 12 bit
- Conversion time: 400 µs for both inputs
- Output format: INT
- Burden: <300 Ω
- Input protection: protection against connection to supply voltage
- Permissible input signal: max. ±30 V
- Conversion method: successive approximation
- Maximum error gain: 0.1%, offset: 0.05%
- Common-mode rejection: DC >50 dB, 50 Hz >50 dB
- Common-mode range: ±11 V
- Crosstalk between channels: <-70 dB
- Non-linearity: <0.1%
- Isolation voltage between channel and bus: 500 Vrms
- Input filter: corner frequency 300 Hz, slope 40 dB

Analog outputs:
- Output: 0 to 20 mA
- Digital converter resolution: 12 bit
- Conversion time: 400 µs for both outputs
- Settling time for output change over full range: approx. 1 ms
- Switch-on/switch-off behavior: internal enable relay for startup and fault condition
- Output protection: protection against connection to supply voltage, short-circuit proof
- Output format: INT 0x0000 - 0x7FFF / 1 LSB = 0x0008 = 4.883 µA
- Load per channel: burden max. 400 Ω
- Output filter: 1st-order low-pass / corner frequency 1.5 kHz
- Maximum error gain: 0.2%, offset: 0.05%
- Isolation voltage between channel and bus: 500 Vrms
- Output response during power supply switch-on/switch-off: enable relay switches on only when a value ≠ 0 is transferred, default setting = 10 kΩ to GND
- Short-circuit proof: current limiting ±40 mA, to GND and sensor/I/O supply Yes

Electrical properties:
- Potential isolation: channel to bus isolated, channel to channel not isolated

Operating conditions:
- Mounting position: any
- Installation altitude above sea level: 0 to 2000 m no restriction, above 2000 m reduce ambient temperature by 0.5°C per 100 m
- Degree of protection per EN 60529: IP67

Ambient conditions:
- Operating temperature: -25 to 60°C
- Storage temperature: -40 to 85°C
- Transport temperature: -40 to 85°C